Effect of organic amendments on the mobility of trace elements in phytoremediated techno-soils: role of the humic substances

The efficiency of aided phytostabilization using organic amendments such as ramial chipped wood (RCW) and composted sewage sludge (CSS) was studied on contaminated techno-soils, on nine experimental plots. The objective was to characterize the role of fulvic (FA) and humic acids (HA) on the mobilization of trace elements, specifically As, Cu, Mo, Pb and Zn. Results showed that the addition of CSS increased the total organic carbon and nitrogen content more than with RCW and as a result, the C/N ratio in the CSS soil was higher than in the RCW and non-amended (NE) soil, reflecting the high decomposition of soil organic matter in the CSS soil compared with the other soils. The RCW and CSS amendments increased the hydrogen index (HI) values and the oxygen index (OI) values compared with the NE soil, especially for the soil treated with CSS which contained more aliphatic than aromatic compounds. The addition of CSS to the techno-soil significantly increased the percentage of C _org associated with the HA fractions compared with the RCW and NE soils. The soil amended with CSS showed the highest E ₄/E ₆ ratio and the lowest E ₂/E ₃ ratio of FA. Zn and As were more abundant in the FA fraction than in the HA fraction, whereas Pb, Cu and Mo were more associated to HA than to FA in the treated and untreated soils, which may explain the difference in their mobility and availability.     

Indoor air quality (IAQ) assessment in a multistorey shopping mall by high-spatial-resolution monitoring of volatile organic compounds (VOC)

In order to assess indoor air quality (IAQ), two 1-week monitoring campaigns of volatile organic compounds (VOC) were performed in different areas of a multistorey shopping mall. High-spatial-resolution monitoring was conducted at 32 indoor sites located in two storehouses and in different departments of a supermarket. At the same time, VOC concentrations were monitored in the mall and parking lot area as well as outdoors. VOC were sampled at 48-h periods using diffusive samplers suitable for thermal desorption. The samples were then analyzed with gas chromatography–mass spectrometry (GC–MS). The data analysis and chromatic maps indicated that the two storehouses had the highest VOC concentrations consisting principally of terpenes. These higher TVOC concentrations could be a result of the low efficiency of the air exchange and intake systems, as well as the large quantity of articles stored in these small spaces. Instead, inside the supermarket, the food department was the most critical area for VOC concentrations. To identify potential emission sources in this department, a continuous VOC analyzer was used. The findings indicated that the highest total VOC concentrations were present during cleaning activities and that these activities were carried out frequently in the food department. The study highlights the importance of conducting both high-spatial-resolution monitoring and high-temporal-resolution monitoring. The former was able to identify critical issues in environments with a complex emission scenario while the latter was useful in interpreting the dynamics of each emission source.     

Release of vanadium from oxidized sediments: insights from different extraction and leaching procedures

Although the attention for vanadium (V) as a potentially harmful element is growing and some countries adopted threshold values for V in soils, sediments, groundwater, or surface water, V is generally of little importance in environmental legislation and the knowledge about the behavior of V in the environment is still limited. In the present study, the release of V from oxidized sediments, sediment-derived soils, and certified reference materials was investigated by means of several types of leaching tests and extractions that are frequently used for soil and sediment characterization. The pH_stat leaching tests and single and sequential extractions applied in this study show that V generally displays a very limited actual and potential mobility in sediment. “Mobile” V concentrations, as estimated by the amount of V released by a single extraction with CaCl₂ 0.01 mol L^?1, were low, even in the most contaminated sediment samples. Only under strongly acidifying conditions (pH 2), such as in the case of ingestion of soil or sediment or in accidental spills, a substantial release of V can be expected.     

Revisions to the derivation of the Australian and New Zealand guidelines for toxicants in fresh and marine waters

The Australian and New Zealand Guidelines for Fresh and Marine Water Quality are a key document in the Australian National Water Quality Management Strategy. These guidelines released in 2000 are currently being reviewed and updated. The revision is being co-ordinated by the Australian Department of Sustainability, Environment, Water, Population and Communities, while technical matters are dealt with by a series of Working Groups. The revision will be evolutionary in nature reflecting the latest scientific developments and a range of stakeholder desires. Key changes will be: increasing the types and sources of data that can be used; working collaboratively with industry to permit the use of commercial-in-confidence data; increasing the minimum data requirements; including a measure of the uncertainty of the trigger value; improving the software used to calculate trigger values; increasing the rigour of site-specific trigger values; improving the method for assessing the reliability of the trigger values; and providing guidance of measures of toxicity and toxicological endpoints that may, in the near future, be appropriate for trigger value derivation. These changes will markedly improve the number and quality of the trigger values that can be derived and will increase end-users’ ability to understand and implement the guidelines in a scientifically rigorous manner.     

Potential use of Caulerpa fastigiata biomass for removal of lead: kinetics, isotherms, thermodynamic, and characterization studies

The present study attempts to analyze the biosorption trend of biosorbent Caulerpa fastigiata (macroalgae) biomass for removal of toxic heavy metal ion Pb (II) from solution as a function of initial metal ion concentration, pH, temperature, sorbent dosage, and biomass particle size. The sorption data fitted with various isotherm models and Freundlich model was the best one with correlation coefficient of 0.999. Kinetic study results revealed that the sorption data on Pb (II) with correlation coefficient of 0.999 can best be represented by pseudo-second-order. The biosorption capacity (q _e ) of Pb (II) is 16.11?±?0.32 mg g^?1 on C. fastigiata biomass. Thermodynamic studies showed that the process is exothermic (ΔH° negative). Free energy change (ΔG°) with negative sign reflected the feasibility and spontaneous nature of the process. The SEM studies showed Pb (II) biosorption on selective grains of the biosorbent. The FTIR spectra indicated bands corresponding to –OH, COO^?, –CH, C?=?C, C?=?S, and –C–C– groups were involved in the biosorption process. The XRD pattern of the C. fastigiata was found to be mostly amorphous in nature.     

Outdoor fine and ultrafine particle measurements at six bus stops with smoking on two California arterial highways—Results of a pilot study

As indoor smoking bans have become widely adopted, some U.S. communities are considering restricting smoking outdoors, creating a need for measurements of air pollution near smokers outdoors. Personal exposure experiments were conducted with four to five participants at six sidewalk bus stops located 1.5–3.3 m from the curb of two heavily traveled California arterial highways with 3300–5100 vehicles per hour. At each bus stop, a smoker in the group smoked a cigarette. Gravimetrically calibrated continuous monitors were used to measure fine particle concentrations (aerodynamic diameter ≤2.5 µm; PM_2.5) in the breathing zones (within 0.2 m from the nose and mouth) of each participant. At each bus stop, ultrafine particles (UFP), wind speed, temperature, relative humidity, and traffic counts were also measured. For 13 cigarette experiments, the mean PM_2.5 personal exposure of the nonsmoker seated 0.5 m from the smoker during a 5-min cigarette ranged from 15 to 153 µg/m³. Of four persons seated on the bench, the smoker received the highest PM_2.5 breathing-zone exposure of 192 µg/m³. There was a strong proximity effect: nonsmokers at distances 0.5, 1.0, and 1.5 m from the smoker received mean PM_2.5 personal exposures of 59, 40, and 28 µg/m³, respectively, compared with a background level of 1.7 µg/m³. Like the PM_2.5 concentrations, UFP concentrations measured 0.5 m from the smoker increased abruptly when a cigarette started and decreased when the cigarette ended, averaging 44,500 particles/cm³ compared with the background level of 7200 particles/cm³. During nonsmoking periods, the UFP background concentrations showed occasional peaks due to traffic, whereas PM_2.5 background concentrations were extremely low. The results indicate that a single cigarette smoked outdoors at a bus stop can cause PM_2.5 and UFP concentrations near the smoker that are 16–35 and 6.2 times, respectively, higher than the background concentrations due to cars and trucks on an adjacent arterial highway.

Implications: Rules banning smoking indoors have been widely adopted in the United States and in many countries. Some communities are considering smoking bans that would apply to outdoor locations. Although many measurements are available of pollutant concentrations from secondhand smoke at indoor locations, few measurements are available of exposure to secondhand smoke outdoors. This study provides new data on exposure to fine and ultrafine particles from secondhand smoke near a smoker outdoors. The levels are compared with the exposure measured next to a highway. The findings are important for policies that might be developed for reducing exposure to secondhand smoke outdoors.     

Probability analyses of combining background concentrations with model-predicted concentrations

In order to calculate total concentrations for comparison to ambient air quality standards, monitored background concentrations are often combined with model predicted concentrations. Models have low skill in predicting the locations or time series of observed concentrations. Further, adding fixed points on the probability distributions of monitored and predicted concentrations is very conservative and not mathematically correct. Simply adding the 99th percentile predicted to the 99th percentile background will not yield the 99th percentile of the combined distributions. Instead, an appropriate distribution can be created by calculating all possible pairwise combinations of the 1-hr daily maximum observed background and daily maximum predicted concentration, from which a 99th percentile total value can be obtained. This paper reviews some techniques commonly used for determining background concentrations and combining modeled and background concentrations. The paper proposes an approach to determine the joint probabilities of occurrence of modeled and background concentrations. The pairwise combinations approach yields a more realistic prediction of total concentrations than the U.S. Environmental Protection Agency's (EPA) guidance approach and agrees with the probabilistic form of the National Ambient Air Quality Standards.

Implications: EPA's current approaches to determining background concentrations for compliance modeling purposes often lead to “double counting” of background concentrations and actual plume impacts and thus lead to overpredictions of total impacts. Further, the current Tier 1 approach of simply adding the top ends of the background and model predicted concentrations (e.g., adding the 99th percentiles of these distributions together) results in design value concentrations at probabilities in excess of the form of the National Ambient Air Quality Standards.     

Optimization-Based Atmospheric Plume Source Identification

This work applies optimization and an Eulerian inversion approach presented by Bagtzoglou and Baun in 2005 in order to reconstruct contaminant plume time histories and to identify the likely source of atmospheric contamination using data from a real test site for the first time. Present-day distribution of an atmospheric contaminant plume as well as data points reflecting the plume history allow the reconstruction and provide the plume velocity, distribution, and probable source. The method was tested to a hypothetical case and with data from the Forest Atmosphere Transfer and Storage (FACTS) experiment in the Duke experimental forest site. In the scenarios presented herein, as well as in numerous cases tested for verification purposes, the model conserved mass, successfully located the peak of the plume, and managed to capture the motion of the plume well but underestimated the contaminant peak.     

Seasonal baseline of nutrients and stable isotopes in a saline lake of Argentina: biogeochemical processes and river runoff effects

The seasonal variability of inorganic and organic nutrients and stable isotopes and their relations with plankton and environmental conditions were monitored in Lake Chasicó. Principal component analysis evidenced the strong influence of the river runoff on several biogeochemical variables. Silicate concentrations were controlled by diatom biomass and river discharge. Higher values of nitrate and soluble reactive phosphorus (SRP) indicated agricultural uses in the river basin. Elevated pH values (～9) inhibiting nitrification in the lake explained partially the dominance of ammonium: ～83 % of dissolved inorganic nitrogen (DIN). The low DIN/SRP ratio inferred nitrogen limitation, although the hypotheses of iron and CO₂ limitation are relevant in alkaline lakes. Particulate organic matter (POM) and dissolved organic matter (DOM) were mainly of autochthonous origin. The main allochthonous input was imported by the river as POM owning to the arid conditions. Dissolved organic carbon was likely top-down regulated by the bacterioplankton grazer Brachionus plicatilis. The δ¹³C signature was a good indicator of primary production and its values were influenced probably by CO₂ limitation. The δ¹⁵N did not evidence nitrogen fixation and suggested the effects of anthropogenic activities. The preservation of a good water quality in the lake is crucial for resource management.